3.2
Installing Skid Shoes
If kit is
NOT
supplied, proceed to
3.3 Installing Gauge Rollers, page 9
. Otherwise, proceed as follows:
NOTE:
This kit may be installed later in the header assembly sequence, but it may be easier prior to laying the
header down.
1.
Unpack skid shoe bundle.
2.
Remove two clevis pins (A) from each skid shoe.
3.
Remove nuts, bolts, and clips (B) from skid shoe.
Figure 3.2: Skid Shoe Bundle
4.
Position skid shoe below cutterbar and insert tabs
on skid shoe into slots (A) in frame.
Secure with
clevis pin (B).
Figure 3.3: Skid Shoe Hardware
5.
Attach clips (A) with bolts and nuts removed earlier in
this procedure to secure skid shoe to cutterbar.
NOTE:
Use a socket and ratchet wrench to access
the nuts.
6.
Tighten nuts.
7.
Remove clevis pin (B) and adjust skid shoe to desired
height. Reinstall two clevis pins (B) and secure with
lynch pins.
8.
Repeat previous steps for opposite side. Set both skid
shoes to the same position.
Figure 3.4: Skid Shoe Installed
147913
8
Revision A
Summary of Contents for A40-D
Page 2: ...A40 D Self Propelled Windrower Auger Header Published May 2016 ...
Page 76: ......
Page 100: ......
Page 119: ......
