PRE-DELIVERY CHECKS
169078
46
Revision E
B. AUGER STRIPPER BAR
CLEARANCE
a. Check for signs of auger flighting rubbing
stripper bars after run-up.
b. Check clearance between auger flighting and
stripper bars.
NOTE
The auger should clear the stripper bars
on the auger pan by approximately
1/32–5/32 in. (1–4 mm). Shimming the
stripper bars may be required.
C. REEL TINE TO HEADER PAN
CLEARANCE
IMPORTANT
The above dimensions are provided as
guidelines only. Tines may slightly
contact the guards but not the knife
sections or the auger pan.
a. Rotate reel slowly by hand, and check tine
clearance at knife and pan. Flex tines to
simulate crop-loaded position to ensure tine
clearances to knife sections and auger pan are
adequate for working conditions.
b. Check that reel rotates freely.
NOTE
If there are a few reel tine that are
touching the pan while the rest are at the
correct height, trim the longer tines to
match the rest. Be sure to adjust both
sides of the reel. Ensure that tines do not
contact plastic header pan.
1/32–5/32 in.
(1–4 mm)
CLEARANCE
1/32–5/32 in.
(1–4 mm)
CLEARANCE
1/32–5/32 in.
(1–4 mm)
CLEARANCE
AUGER
FLEX TINE BACK
0.08–0.39 in.
(2–10 mm)
0.08 in.
(2 mm)
Summary of Contents for A30-S
Page 55: ...NOTES 169078 53 Revision E ...