UNLOADING AND ASSEMBLY
169078
21
Revision E
DANGER
To avoid bodily injury from fall of raised
header, always engage header lift cylinder
stops when working on or around raised
header, and before going under header for
any reason.
g. Cylinder stops are located on both header lift
cylinders on the windrower. Engage lift cylinder
stops on both lift cylinders as follows:
1. Stop engine, and remove key from ignition.
2. Pull lever (L), and rotate toward header to
release and lower cylinder stop (M) onto
cylinder.
3. Repeat for opposite lift cylinder.
h. Install pin (N) through each boot and foot, and
secure with hairpin.
IMPORTANT
Ensure pin (N) is fully inserted, and hairpin
is installed behind bracket.
i.
Remove lynch pin from pin (O) in stand (P).
j.
Hold stand (P), and remove pin (O).
k. Re-position stand to storage position by
inverting stand, and re-locating on bracket as
shown
l.
Re-insert pin (O), and secure with lynch pin.
m. Remove pin (Q) from storage position in linkage,
and insert in hole (R) to engage float springs.
Secure with lynch pin.
n. Disengage lift cylinder stop by turning lever (L)
downward to raise stop until lever locks into
vertical position.
o. Repeat for opposite cylinder
s
top.
(continued next page)
P
O
N
L
M
L
Q
R
Summary of Contents for A30-S
Page 55: ...NOTES 169078 53 Revision E ...
