UNLOADING AND ASSEMBLY
169078
20
Revision E
HYDRAULIC LINK WITHOUT
SELF-ALIGNMENT KIT
1. Activate HEADER TILT cylinder switches on
GSL to extend or retract center-link cylinder
(E) so that the hook lines up with the header
attachment pin.
2. Stop engine, and remove key from ignition.
3. Push down on rod end of link cylinder (E)
until hook engages pin on header, and is
locked.
IMPORTANT
Hook release (J) must be down to enable
self-locking mechanism. If the release is
open (up), manually push it down after
hook engages header pin.
4. Check that the center-link is locked onto
header by pulling upward on rod end of
cylinder.
5. Proceed to step f.
MECHANICAL LINK
DANGER
Stop engine, and remove key from ignition
before leaving Operator's seat for any
reason. A child or even a pet could engage
an idling machine.
1. Stop engine, and remove key.
2. Loosen nut (F), and rotate barrel (G) to
adjust length so that other end lines up with
header bracket.
3. Install pin (H), and secure with cotter pins.
4. Adjust link to required length for proper
header angle by rotating barrel (G). Tighten
nut (F) against barrel. A slight tap with a
hammer is sufficient.
f. If engine is not running, start engine, and press
HEADER UP switch to raise header to maximum
height.
NOTE
If one end of the header does not raise
fully, the lift cylinders require re-phasing.
If re-phasing is needed, proceed as
follows:
1. Press and hold HEADER UP switch until
both cylinders stop moving.
2. Continue to hold the switch for 3-4 seconds.
3. Cylinders are phased.
4.
WARNING
Stop windrower engine, and remove key
before making adjustments to machine. A
child or even a pet could engage the drive.
(continued next page)
G
F
H
HEADER UP
HEADER TILT UP
HEADER
TILT DOWN
REEL UP
REEL DOWN
HEADER DOWN
J
E
Summary of Contents for A30-S
Page 55: ...NOTES 169078 53 Revision E ...