MacDon A30-S, Unloading And Assembly Instructions

Page: 25 / 56

UNLOADING AND ASSEMBLY
169078
23
Revision E
STEP 14. MODIFY HYDRAULICS
A. A30-S
The M100, M105, M150 and M155 are factory-
configured with A30-S header hydraulics and
electrical harness. Proceed to
STEP 15.
CONFIGURE REVERSER VALVE JUMPER
HOSE.
M200 hydraulics need to be reconfigured to run
an A Series header. Kit B4651 (available
through your Dealer), includes the additional
hose, hardware, and installation instructions.
Install the kits in accordance with instructions
that were supplied with the kits. Then, proceed
to
STEP 15. CONFIGURE REVERSER VALVE
JUMPER HOSE.
M205 hydraulics need to be modified to accept
an A Series header, and kits B5491, B5492, and
B5497 should have been supplied with your
header. Install the kits in accordance with
instructions that were supplied with the kits.
Then, proceed to
STEP 16. ATTACH
HYDRAULICS.
B. A40-D
I. M100, M105
a. Open LH maintenance platform, and modify
valve block as follows:
1. At valve (D), remove the cap (E) from port
‘R1’ fitting, and the plug (F) from ‘DWA’ tee
fitting. Ports may not be identified.
2. Remove female coupler assemblies (G) and
(L) from auger return and reel pressure hose
bundle (H) from header.
3. Remove and discard cap (M) and adapter
fitting (N) with O-ring, from the large coupler
(O).
(continued next page)
DWA
E
F
D
R1
LARGE COUPLER ASSEMBLY (L)
M
N
O
H
L
G