Sensopress_LCD_Rev_00_Eng.doc Eng
12
4.3.1
CHANNEL Mode
This mode is possible only with the multi-channel version and it is used for :
•
To enable or not the wanted channel.
o
!Attention: if the channel is disabled, the corresponding relay, even if the liquid’s
level oversteps the set-up thresholds for that channel, does not get active.
•
Choose the channel to modify the intervention thresholds.
•
Choose the channel to visualise when in the
AUTO
mode.
It is possible to enter the
CHANNEL
mode from any other mode, by choosing the sign
GO to
CHANNEL
with the
Menu
button and by pushing
Yes/+
.
To enable/disable the channel:
•
Choose the channel by pushing the button
Yes/+
, the chosen channel is indicated on the
low left side of the display as shown in Figure 6.
•
Push the button
No/-
to enable/disable the indicated channel. The indication of the channel’s
state is visualized on the low right side of the display as shown in Figure 6.
•
In particular:
o
ACTIVE
= enabled channel
o
INACTIVE
= disabled channel
The channel that stays chosen on the display, no matter if active or not, is the one visualised in the
AUTO
mode and it is the one on which it is possible to change the thresholds in
LOW
and
HIGH
mode.
Figure 6
Current mode
Channel’s state:
ACTIVE: the relay commutes in function of the set-up
thresholds.
INACTIVE: the relay does not commute even if the threshold
overstep.
To enable/disable the channel push button No/-
Chosen channel.
Push the button Yes/+
to change channel
