40
47DT OPERATING MANUAL EM-9508-B Rev.7
2. BASIC SETTING AND OPERATION
2.1 BASIC SETTING
This section describes flow and procedure of the basic setting.
The following shows the flow and procedure to set the input type to the thermocouple T (CC), the temperature unit to °C
and the decimal point position to 1 decimal place as an example.
2.1.1 BASIC SETTING FLOW
The basic setting is as shown in the following flowchart.
2.1.2 BASIC SETTING PROCEDURE
The following shows the procedure to set the input type to the thermocouple T (CC), the temperature unit to °C and the
decimal point position to 1 decimal place as an example. Set a thermocouple, temperature unit and decimal point position
to use. Refer to 3. SETTING INPUT TYPE for details of setting.
■
PARAMETER LIST FOR BASIC SETTING
Parameters used in the basic setting are as shown in the following table.
PARAMETER
SETTING VALUE
SUB DISPLAY
SETTING
Input type
TYPE T
TCTYPE
T (CC) thermocouple
Temperature unit
C
UNIT
Temperature indication in °C
Decimal point position
0.0
D-POINT
1 decimal place
Power ON
Starting measurement
Setting temperature unit
Setting input type
Setting decimal point position
