28
BASIC OPERATION
TURNING ON THE RADIO
1.
Power ON the radio by rotating the POWER ON-OFF/VOLUME knob
clockwise. A short alert signal (if enabled through programming)
indicates the radio is ready to use. Refer to Figure 3 for location of the
POWER ON-OFF/VOLUME KNOB.
2.
The display shows the last selected system and group or a default system
and group (depending on programming).
3.
Adjust the POWER ON-OFF/VOLUME knob to the desired volume
level.
4.
Select the desired system and group. The display indicates the current
system and group names.
5.
The radio is now ready to transmit and receive calls.
NOTE
In the trunked environment,
CC SCAN
will be displayed if
communication with the system's control channel cannot be
established. This may occur if, for example, the radio is out
of range of the trunking site. It may be necessary to move to
another location or select another trunking system to re-
establish the control channel link for trunked mode
operations.
CC SCAN
is displayed on the group line until
a control channel is accessed.
SYSTEM SELECTION
Method 1 (System Model)
1.
Press
to access system list.
2.
Press the numeric key, which is mapped to the desired system.
3.
Press
. The radio will move to the selected system.
Method 2
1.
Rotate System/Group/Channel knob to desired system number position,
or
2.
Press the
buttons to change systems. The display registers the
new system name on line one.
