41
Press
a third time to set the group to Priority 1. A is displayed on line
three. The priority level selection sequence only advances the group to next
higher priority level and stops at priority level 1. To select a lower priority
level, the group must be deleted from the scan list and then added back to the
scan list. Each new group added to the scan list starts at the lowest priority. If
the Priority 1 and Priority 2 groups are already set and a new group is assigned
as Priority 1 or Priority 2, the previously assigned group will change to non-
priority scanning. One of the following messages may be momentarily
displayed:
SCAN DIS
The radio is not programmed to scan.
FIXED P1
A Priority 1 group has been pre-programmed into the radio. A
new Priority 1 group cannot be selected.
FIXD LST
A fixed scan list has been pre-programmed into the radio. It is
not possible to change the list without reprogramming the radio.
NOTE
To quickly view multiple group scan status, press either
or
the
key. Then slowly but consistently rotate the group
knob. Each group status will appear on the display.
Deleting Groups from a Scan List
Scan Model
1.
With scan operation turned OFF, select the desired group to delete from
the selected trunked system group scan list.
2.
Press
. The current status of the group is displayed for a time-out
period.
While the current status is displayed, press
. until the group from the scan
list is "
blank
". The sequence is "
blank
", , , ,"
blank
". Any group that is
not in a trunked system group scan list will show a "
blank
" for the time-out
period when it is the selected channel.
System Model
1.
With scan operation turned OFF, select the desired group to delete from
the selected trunked system's group scan list.
2.
Press
. The current status of the group is displayed for a time-out
period.
