Lyngdorf TDAI-2170, Owner'S Manual

Page: 16 / 60

16
Placing the microphone in the focus position
When you are prompted to place the microphone in the focus position, connect the microphone to the
microphone input on the back panel and place the microphone, using the microphone stand, in your
primary listening position. The height and the orientation of the microphone should correspond to your
head’s height and direction.
Press enter and a test signal will start from the left speaker. The TDAI-2170 will give an estimated
optimal volume for calibrating the system or will accept the current volume. Adjust the volume if
required and retry the measurement.
The calibration volume should not be so loud that it is inconvenient to you, or that it causes damage
to your loudspeakers. If this is the case, set it to a lower and more appropriate level. A low volume can
result in a longer calibration time or a measurement time out. A low volume and long measurement will
not affect the quality of the end result.