Hardware Configuration
31
E-EQ-MX6PCRG-C-ARC
MX6 PPC Reference Guide
Secure Digital Cards
Note: When removing or installing Secure Digital (SD) cards, protect the MX6 PPC internal
components from electrostatic discharge.
SD memory interface cards are used for expanded data storage. SD cards are neither installed nor
supported by LXE.
Note:
LXE recommends purchasing preformatted SD cards.
SD Installation / Removal
Figure 3-2 Secure Digital Memory Interface Card Location
Equipment required: A phillips screwdriver (not supplied by LXE)
•
LXE recommends that installation/removal of cards be performed on a clean, well-lit
surface.
•
Anti-static protection is required when installing/removing cards. (Not supplied by LXE)
•
If you anticipate keeping a card out of the MX6 PPC for a long period of time place it in
a static-free storage container. Store in an area that is protected from dirt, moisture, and
electrostatic contact.
Important
The SD card is approximately the size of a postage stamp (32mm x
24mm). Make sure the work area is clean and uncluttered before
removing the card from it’s packaging.
Installation
1.
Turn the MX6 PPC off and remove the main battery pack.
2.
Using a screwdriver, loosen the SD Access Door on the left side of the MX6 PPC.
3.
Remove the rectangular rubber protective seal over the SD card opening.
4.
Set the door, protective seal and the screws aside.
5.
Slide the Card, connector side first, into the slot until it seats. Use caution not to pull or snag
any cables that may be in the vicinity of the card.
6.
If the card is difficult to seat in the slot, remove the card, turn it around and re-install.
7.
Place the access door back in the opening and secure with the screws.
8.
Replace the main battery pack and perform a Warm Reset.
