Power mode:
Redundant
, the second PSU is used as redundancy in case an error occurs with the first PSU.
Shared
, the output power of both PSU’s is combined to offer a higher total output power available
across all the switch ports.
If the switch does not support PoE, this section is greyed out.
SNMP
Enable/disable SNMP (Simple Network Management Protocol). Here you can configure whether you want
to use SNMP. By default SNMP is disabled.
DEFAULT PROFILE
By clicking the check-box, the user can protect the profile stored in slot #1 from being deleted or
overwritten.
When the user performs a Reload Defaults from the front panel mode button (see Reload Default in the
Reset chapter of this manual), the device will reboot into profile #1. This is a handy tool to quickly recall
your favourite profile.
Once the first profile is protected and set as default, a padlock will appear on slot 1 on the profile tab.
LED BRIGHTNESS
The LED slider allows you to change the brightness of the port mode LEDs and the status LEDs on the
GigaCore. The port mode LEDs can be dimmed to OFF but the status LEDs will always stay visible.
The brightness of the link LEDs is not affected.
3 | confIGuratIon
25
