12
Luma 300 Series Wi-Fi Cube IP Camera
PIN Mode
PIN mode requires you to enter a personal identification number (PIN) to connect the network.
1. Go to
Configure This Computer > Advanced Network Settings > Wi-Fi
2. Check the
Enabled
box.
3. Select your system’s SSID from the Wireless List.
4. Do not make any changes to Network Mode (‘Manage’), Security Mode, Encryption Type or Key 1.
5. Check the checkbox to enable WPS.
6. Choose
Use route PIN code
. Use one of the two methods below to connect.
Generate a PIN with the Camera
To generate a PIN with your camera, click the
Generate
button. A generated PIN code expires in 120 seconds.
Thus you have 2 minutes to enter this PIN in your router in order to connect the Wi-Fi camera. If the process fails
or you exceed the 2-miute time limit, try again.
Use the PIN from the Router
Enter the PIN code from the router (found on the router’s label or in your router’s interface) and click the
Connect
button. You will get a ‘connection succeeded’ alert from the IP camera’s interface.
Complete the Installation
Finish the installation by following the steps under
Confirm and Lock the Settings
on the page 10.
