Chapter 3 Operation
56
1. Cursor Up / Increase Values
Move the cursor up or increase values.
2. Escape
Escape from
sub-menu or sub-selection
3. Cursor Down / Decrease Values
Move the cursor down or decrease values.
4. Enter
Enter into sub-menu or confirm the selection.
5. Previous
Select previous file in file list.
6. Next
Select next file in file list.
7. Stop
Give up the file that is in pause mode. You can’t stop file directly which is not in pause
mode.
8. Run / Pause
Run the file when system is ready or in pause mode. Pause the file when it is running.
9. Move Carriage to P1
Move the carriage to the
location
of P1. The way to set
location
of P1, please see
section
3.3.2
10. Move Carriage to P2
Move carriage to the
location
of P2. The way to set
location
of P2, please see section
3.3.2
11. Red Beam Switch / Lase
Turn on/off the red beam normally.
But if in the sub-menu of
[Alignment mode]
(See section
3.3.2
), this key will turn
to emit the laser beam for alignment.
12. Move Carriage Left (X-)
Move the carriage left slowly when press this key shortly. If you want to move the
carriage left faster, please press and hold this key.
13. Move Carriage Right (X+)
Move the carriage right slowly when press this key shortly. If you want to move the
carriage right faster, please press and hold this key.
Summary of Contents for i.LASER Series
