LTS LTN8704-P4, User Manual

Page: 158 / 217

User Manual of 87XX-P Series NVR
158
Figure 11. 42 Connect to IP Camera
5. Click the link and the page of IP camera management appears.
11.2.14 Configuring Telnet
Purpose:
Telnet function provides an easy way to get access to the NVR. You can see the advanced information about the
device by inputting command; as well the configuration can also be realized through telnet connection.
Steps:
1. Enter the Advanced settings interface, as shown in the Figure 11. 41.
Configuration > Remote Configuration > Network Settings > Advanced
2. Check the checkbox of the Enable Telnet .
3. Click the Save button to save the setting.
4. You can open the Command Prompt window in your PC, and input “telnet IP Address ” to connect with the
NVR, as shown in the figure below.
Example:
If the IP address of the NVR is 192.0.0.64, you can input “telnet 192.0.0.64” and then press Enter to connect
to the NVR.
Figure 11. 43 Connect to NVR
The telnet function turns invalid after the device shutting down or rebooting, you have to enable it again if
required.