Lotus EMIRA 2022, Owner'S Handbook Manual

Page: 200 / 252

200
to cool down before they are checked
and adjusted to the correct inflation
pressures for road use. Refer to the
‘Technical Data’ section for further tyre
pressure information.
Due to the severity of tyre operating
conditions, extra vigilance is required
for vehicles used on a race track or
in a competitive manner. Careful
inspections must be carried out before
and after each session.
N
NOTE: Lotus does not endorse
such use of the Emira - refer to
the Warranty Booklet section 2
‘Intended Purpose’.
Michelin Pilot Sport Cup 2 Tyres
IMPORTANT: If fitted, the Michelin Pilot
Sport Cup 2 tyre provides outstanding
grip and traction when used in dry
conditions above 7 degrees Celsius.
The lower tread profile does present
a greater risk of aquaplaning on wet
roads and grip can be reduced when
driven in cold weather. Drivers should
exercise caution and drive in a style
according to the road conditions.
Adjusting Tyre Pressures
N
NOTE: To avoid incorrect tyre
pressures, the pressures should be
checked on cold tyres as previously
described in this section.
1. Remove the dust cap from the valve
on one tyre and then press the tyre
pressure gauge firmly down onto the
valve.
2. Inflate or deflate the tyre to the
correct pressure, see the decal on
the driver’s side door pillar showing
the recommended pressure for
factory fitted tyres.
3. Refit the dust cap.
4. Check the tyre for any cuts,
imbedded objects (such as nails that
could cause a puncture or leakage),
abrasions, bulges, other damage and
for any uneven tread wear patterns.
5. Repeat this procedure for all tyres.
6. Refer to page 206, ‘Calibrating tyre
Pressure Monitoring System’.
WARNING: Over-inflated tyres are
more likely to be cut, punctured or
broken by a sudden impact.
WARNING: Improperly inflated
or worn tyres are more likely to
aquaplane in wet conditions.
WARNING: Over or under-inflated
tyres can overheat, resulting in a
blowout which may cause a serious
accident.
N
NOTE: Always replace the tyre
valve dust cap to prevent the
ingress of dirt and moisture into
the valve, which could cause
leakage.
N
NOTE: Only plastic dust caps
should be fitted. Fitting a metal
cap may cause corrosion making it
difficult to unscrew or even cause
valve damage.
VEHICLE CARE