51
Connecting Motion / Alarm Device - Appendix #5
Connecting Motion / Alarm Device - Appendix #5
Motion detection and Alarm controls are enabled through the Menu system on the Observation
System. Additional motion sensor devices can be connected to the system (Motion Sensors,
Door/Window Sensors).
A motion detection or sensor unit can be used to send a signal to the Observation System to
begin camera viewing on the matching Video Channel (when enabled in the Menu, see page
39
):
• Example: A Window sensor unit has been installed on Alarm Block port #4. When this sensor
is activated, the camera on DIN or BNC VIDEO port #4 will become active (if enabled in the
MENU on the Observation System)
Installing a Sensor
1. Connect the GROUND Cable to the GND port on the Alarm Block on the Observation System
(ports 3, 4, 5 or 6 - see FUNCTION chart below).
2. Connect the SIGNAL Cable to a numbered port (ports 7, 8, 9 or 10 - see FUNCTION chart below).
To start ALARM RECORDING on the System, refer to page
39
for menu configurations.
SENSOR
(Not Included)
OBSERVATION SYSTEM
Summary of Contents for L15LD400 series
Page 59: ......
