Lorex L15LD400 series, Instruction Manual

Page: 17 / 59

17
Camera Installation
Camera Installation
Before you install the camera, carefully plan where and how you will position the camera, and
where you will route the cable that connects the camera to the System.
Installation Warnings:
• Select a location for the camera that provides a clear view of the area you want to monitor,
which is free from dust, and is not in line-of-sight to a strong light source or direct sunlight.
• Plan the cables’ route so that it is not close to power or telephone lines, transformers,
microwave ovens or other electrical equipment that could interfere with the system.
• Select a location for the camera that has an ambient temperature between 14
°
F~113
°
F
(-10
°
C~45
°
C)
• If you plan to install the camera in a location that has conditions not recommended in this
manual, consult with a professional installer and consider use of a separate camera cover
or housing
• Before starting permanent installation, have another person hold the camera for you while
you verify its performance by observing the image on the monitor.
Camera Stand Installation:
1. Attach the pedestal to the ceiling, wall or other surface by the base using the provided
screws.
2. The mounting bracket must be attached to
a structural device such as a wall stud or
ceiling rafter using the supplied screws.
3. Attach the camera to the pedestal. Adjust
the angle of the camera, and tighten the
thumbscrew to set the position
NOTE : The Camera can be attached to the stand
using the screw point on the top or the bottom (to
maintain proper camera alignment). This prevents
the image from becoming inverted.