1)
switch (230) ‘ON/OFF’ for the heater powering;
2)
red lamp (231) ‘HEATER IS ON’
3)
green lamp (232) ‘HEATER READY’
There are two connectors Ш1 (233) and Ш2 (234) on the front side for controlling and powering.
The heater has the carrying handle (235).
Figure 32. Heater
5.7.12. Monitoring units
The monitoring units consist of the monitor and terminal box.
5.7.12.1. Monitor
The monitor is shown on the Figure 33.
It is metal body (240) with different element on it’s top:
1)
voltmeter (241) for monitoring the power;
2)
ammeter (242) for monitoring overall consumption current;
3)
voltmeter (243) for monitoring a motor and tacho-generator voltage;
4)
ammeter (244) measuring the motor current;
5)
switch (245) ‘Voltage Monitor’;
6)
switch (246) ‘Generator ON’ for built-in 100Hz generator;
7)
switch (247) ‘POWER’ for measuring a motor and tacho-generator voltage.
The panel has following sockets:
1)
socket (249) ‘
U
TG
’ for output the tacho-generator signal to an oscilloscope;
2)
socket (250) ‘Pulse sensor’ for output the sensor signal to an oscilloscope;
3)
socket (251) ‘100Hz’ for output the generator signal to a frequency meter.
Other elements are mounted inside the body.
Rear side of the monitor has the connector for the terminal box. Bottom side has four dampers. The monitor has the carrying
handle.
Summary of Contents for GLADIOLUS
Page 6: ...Figure 2 Kinematics ...
