Figure 11. Electric circuit of the monitoring unit
5.7. Construction and operation of the basic parts
5.7.1. The camera
The camera is pictured on the Figures 12, 13. It is the body (51) (Figure 12) with gears inside.
5.7.1.1. The camera body
The body has the frond side (53) (Figure 12) attached to it by means of the screws (52). The front side has lens mount. A lens
body has the ring (54) to attach a bracket for heavy lens support. The ring and body are fastened to the brackets by means of the
screws (55). The housing (56) covers the motor. The cap (57) can be taken off for manual turn of the camera gears.
There are two bearing sleeves for the brackets (59) on the camera body to the right of the lens mount. The bracket (the small
bracket is pictured) is fastened to the bearing sleeves by means of the screws (58). Third bearing sleeve situated at the front side
of the camera, and the bracket is fastened to it by means of the screw (60).
Rear right part of the camera contains the motor unit. The motor unit consists of motor (1) (Figure 13) which flange is fastened
to the body by means of the screws (61). Console part of the motor is supported by the brackets (62) (one bracket is pictured).
The tacho-generator is coupled with the motor shaft and secured by means of the screw situated in the “A” hole.
Bottom slope of the camera has the connector (63) for connecting the camera with the control button of the hand support.
The bracket (62) has the connector (64) connection the control unit and the camera. Bottom part of the camera has the plate (65)
with tripod nuts in it.
The lens mount has the bayonet ring (66) with locking ring (67).
Summary of Contents for GLADIOLUS
Page 6: ...Figure 2 Kinematics ...
