page 26
cleaning brush
seal
baffle plate
baffles
control knob
heat exchanger cleaning
Cleaning the heat exchanger
Behind the upper maintenance door there is a cleaning aperture. the cover is
attached to the body of the appliance by two wing nuts.
remove the baffle as well as the baffle plates (3 pcs.) to clean the surfaces
of the heat exchanger. Check the seal for damage and if necessary replace it
before screwing on again (Figure 65)
remove deposits from the surfaces of the heat exchanger as well as from the
heat exchanger pipes using the supplied cleaning brush . (Figure 66)
Cleaning heat exchanger
(optional equipment)
easy cleaning of the heat exchanger tubes through built-in heat exchanger
(Figure 67).
Combustion chamber ash pan
remember to empty the ash pan regularly and in good time (Figure 68).
to do this, swivel the grate using the supplied grate lifter (1).
use the grate lifter to remove the ash pan towards the front (2+3) and empty
it, and clean the ash chamber.
pellet burner ash pan
Open the door of the pellet extension and pull out the ash drawer (Figure 69).
empty the ash drawer and clean the ash chamber.
Grate
If the air slits are very clogged by slag, crusts or other combustion residue,
completely remove the grate and clean it (Figure 67).
to do this, open the combustion chamber door and lift the grate with the grate
lifter (1) and pull out towards the front.
The pile of ash must not obstruct the primary air vents in the ash pan.
The pile of ash must not obstruct the primary air vents in the ash pan.
CAUTION: The ash drawer may be hot
CAUTION: The ash drawer may be hot
CAUTION: The ash drawer may be hot
CAUTION: The ash drawer may be hot
The heat exchanger cleaning which is available as optional equipment can also be
fitted at a later time.
The heat exchanger cleaning which is available as optional equipment can also be
fitted at a later time.
Figure 65
Figure 66
Figure 67
Figure 68
Figure 69
1
2
3
primary air
vents
Summary of Contents for Aqua Insert+P
Page 35: ...Seite 35...
