SCRUB SINKS USE & INSTALLATION GUIDE
www logiquip com
|
5
GENERAL SPECIFICATIONS
1. Material
• Sink basin and sink top: 14 gauge, 300 series stainless steel
• Sink skirt: 18 gauge, 300 series stainless steel
2
Plumbing Material
• 1/2” copper or brass pipe
• Sink is furnished with in-line check valves on supply lines
3
Utility Requirements
• Cold Water - 20 to 50 psig 70º F max
• Hot Water - 20 to 50 psig 120º F to 140º F
• Water Lines should be flushed clean before water connections are made
• It Shall Be The Customers Responsibility
• To ensure by use of pressure regulators or other means, that maximum specified pressures are not exceeded
• To ensure that water supplies are properly protected for internal cross-connection control in accordance with local building
and plumbing requirements
• To eliminate water hammer conditions should they occur in the service piping
4
Power Requirements (For Sinks With Optional Infrared Sensor Operations)
• 120 Volt, 60 Hz, single phase, 3 0 amp GFIC protected electrical outlet (by others)
• 220 VAC, 60 Hz, single phase 1 5 amp
• To be installed per local building codes
5
Sink Weight
• 1-Station - 130 lbs
• 2-Station - 230 lbs
• 3-Station - 320 lbs
6
Sink Certifications
• UL and cUL Certified
• California OSHPD pre-approved when mounted on a structurally sound wall
7
Mixing Valve Specifications
• Connections - 1/2” NPT Inlets and 1/2” NPT Top Outlet
• Capacity (without checkstops) - 5 25 gpm [19 9 L/min - at 45 psi differential (310kPa) with hot water supply between 140° -
180° F (60° - 82° C) and 50/50 mix}] - (±0 25 gpm [0 95 L/min])
• Maximum Hot Water Supply Temperature - 190° F (88° C)
• Minimum Hot Water Supply Temperature (not applicable to low temperature hot water valves - 5° F (2 8°C)
above set point)
• Temperature Ranges - ASSE 1016 Type T: 65-115°F (18-46°C); ASSE 1016 Type T/P: 90-110°F (32-43°C)
• Maximum Operating Pressure - 125 psig (862 kPa)
• Maximum Static Pressure - 125 psig (862 kPa)
• Compliant - ASSE 1016-T-P
• Certified - CSA B125
