LOFTNESS GrainLogix GBL12A, Owner'S Manual And Parts Book

Page: 31 / 150

23 Grain Bag Loader OM
Set-up Instructions
Initial Set-up (Cont’d)
Swing Auger Installation (GBL12 only)
(Cont’d)
1
3 4 5
2
2
When the auger is seated properly, the flange (1) on the
end of the spout should lay flat onto the boot inside
mounting plates (2) .
Secure in place using a 2-13/16" steel washer (3), 3/8"
lock washer (4) and 3/8" x 1" bolt (5) . The nut is welded to
the inside of the boot . Repeat procedure on the remaining
five locations around the flange .
Rotate the swing auger to ensure correct setup .
Tighten bolts securely against the swing auger swivel .
Remove lifting sling/strap and forklift
Re-install the inspection cover .
Swing Hopper/Tube Assembly (GBL12 only)
1
2
3
Install a woodruff key (1) and apply a thin coating of anti-
seize compound on the swing flight shaft (2) .
Move the hopper toward the swing tube and slide the
u-joint onto the swing flight shaft (2) .
NOTE: Do not install a set screw at (3).
NOTE: The u-joint must slide on easily. Buff the shaft
and inside the u-joint if necessary.
1
2
Install the two rubber latches (1) in the small brackets on
the sides of the transition section .
Secure the 13 in . hopper transition to the hopper using
two 3/4" x 2" bolts (installed from the inside out) and 3/4"
stover locknuts (2) .
NOTE: Do not over tighten the nuts. The transition must
be able to rotate on the hopper.