LOFTNESS GrainLogix GBL12A, Owner'S Manual And Parts Book

Page: 42 / 150

34 Grain Bag Loader OM
Set-up Instructions
Install the pressure and the return hydraulic hoses into the
tractor’s hydraulic connectors at the rear of the tractor.
Install the 7-pin electrical harness to the tractor’s
electrical connector.
NOTE: Install the electric winch cable connections
directly to the tractor battery (12 Volts are
required).
Secure the electrical harness, winch harness and all
hydraulic hoses up and away from the PTO driveline area.
Connecting the Grain Bag Loader
(Cont’d)
1
2
Retract sleeve (1), slide the PTO driveline (2) onto the
tractor PTO shaft until the sleeve slides forward and
locks driveline to shaft. Push and pull the PTO driveline
back and forth several times and make sure it is securely
attached to the PTO shaft.
The PTO driveline is telescopic to fit most lengths.
The connection should be never more or less than 3-4
inches (7.6-10 cm) away from the tractor connection. If
the distance is more or less than that, refer to the PTO
driveline manufacturer’s literature for procedures for
adjusting the length. Also, the PTO angle should not
exceed 25°.
CAUTION: Never use a steel hammer when
connecting or disconnecting a PTO shaft.
CAUTION:
DO NOT USE PTO ADAPTERS OF
ANY KIND.
CAUTION:
The hydraulic system is under
high pressure. Make sure all lines and fittings
are tight and in good condition. These fluids
escaping under high pressure can have
sufficient force to penetrate skin and cause
serious injury.