LOFTNESS GrainLogix GBL12A, Owner'S Manual And Parts Book

Page: 28 / 150

20 Grain Bag Loader OM
Set-up Instructions
Initial Set-up (Cont’d)
Main Auger Installation (Cont’d)
1
1
2
2
3
Install the two connector strap assemblies over the
tunnel frame (1) and hitch frame (2) (both sides) .
Install the remaining two connector straps (3) . Install flat
washers and nuts on the four bolts .
Tighten the four bolts/nuts evenly . As the bolts/nuts are
tightened, the connector straps will pull the two frames
together . Continue to tighten the four bolts/nuts until the
two frames contact each other and no gap remains .
1
2
3
Install one flat washer onto the 3/4" x 3" Grade 5 bolt .
Install 3/4" x 3" Grade 5 bolt w/washer (1) through
the base assembly and main auger assembly upper
mounting plates . Install one flat washer (2) and nut (3)
(both sides) and tighten nut .
1
2
Remove retaining pin (1), rotate the jack (2) to the
operation position and re-install retaining pin . Raise/
lower the jack until the main auger assembly is level .
Remove the forklift from the hitch .
1
Install the second retaining ring/clamp (1) around the
main auger and sleeve . Tighten the retaining ring/clamp .