LOFTNESS GrainLogix GBL12A, Owner'S Manual And Parts Book

Page: 30 / 150

22 Grain Bag Loader OM
Set-up Instructions
Initial Set-up (Cont’d)
Mounting The Swing Auger (GBL12 only)
Clean the 21-spline shaft on the gearbox in the boot as
well as the u-joint in the spout of the swing auger . Apply
anti-seize compound to the splined shaft .
1
1
1
1
Remove the six bolts (1), lock washers and washers .
Swing Auger Installation (GBL12 only)
1
2
Install a lifting sling/strap (1) around the swing auger .
NOTE: Use lifting slings/straps that are in good condition
and of adequate size to lift the swing auger.
Remove cover (2) .
NOTE: Removing the cover will allow the installer to
visually align the swing auger with the gear box
shaft.
1
2
Move the swing auger (1) over the gearbox shaft (2) .
1
Using a stick or a piece of metal, guide the u-joint (1)
onto the boot gearbox while slowly lowering the swing
auger .
WARNING: Do not place hands in the intake
boot while performing this operation. Severe
injury will result!
NOTE: Rotate the u-joint to align the splines.