Loepfe YarnMaster Zenit, Instruction Manual

Page: 61 / 83

ZENIT 61
CLASS DATA
Class Data
Class Clearing Data
YarnMaster Zenit classifies all yarn faults in every group and
for every spindle. Faults of the yarn to be cleared are assigned
to certain fault classes based on the length and diameter.
Using this detailed information concerning the count as well
as length and thickness of the yarn faults, an optimum set-
ting of the clearer parameters can be performed very fast and
effectively.
The numbers in the individual class fields indicate the cuts
and fault sums which remained in the yarn for the corre-
spond ing classes relative to the wound length which is dis-
played on the screen.
ƒ
Red numbers = Cut yarn faults
ƒ
Black numbers
= Yarn “faults” remaining in the yarn
Coarse yarn limitation
If the coarse yarn limitation has
been activated, cuts and classifications above the coarse yarn
limitation are added to the respective classes below this line.
This data can be optionally viewed per spindle or group.
In case of classification per spindle, the last cut fault is also
shown in its respective class field. The exact cut position is
indicated (marked green). This indication is revised at the next
spindle stop.
Total Cuts displays the sum of the cut faults of the com plete
class fields.
Note : Due to the completely independently operating soft-
ware of the conventional clearing and the classification, it is
possible that faults which correspond to a short and a long
fault are displayed as cut below the clearer curve.
Mode
Coarse or fine classification can be selected:
ƒ
Coarse = Classification data of the 23 main classes
ƒ
Fine = Classification data of all 128 classes
Selection / Cut Declaration
See
Monitoring Data
.
Classification per spindle