40
Operation of LZE-V
1N1 / 3N1
5.11 Article Settings
Setup > Articles
The major clearer channels can be set by the selection of classes within the
clearer matrix through the touch screen. Each class is limited by a length and
deviation limit which both can be set individually within certain limits.
A red class is activated for clearing, a yellow one can be selected in addition.
The light yellow classes are disabled by the system.
The additional clearer channels can be set by entering a setting within the
specified limits.
The range for all settings can be found in the chapter
Technical Data /
Parameter Settings
, but the range will also be shown in the data entry window
while changing a setting.
5.11.1
Quality (Q) (1N1 / 3N1)
The yarn clearing to control the yarn structure is activated by setting classes
within the clearer matrix. The length and deviation limits of the classes can be
set individually within certain limits.
1. Enter the yarn count to the intended window. The right yarn count is nec-
essary for the calculation of the production weight and other calculations.
2. Parameters for the longer defects can be set in the two columns “
Stops
”
and “
Locks
”.
Stops
are used for longer defects below 5 m, which can be removed from
the package with the piecing robot.
Thick and Thin Sliver
for detection of misplaced cans or partly decreasing /
increasing of the sliver diameter.
Moiré:
Length of the fault depending on rotor diameter.
Neps Sensitivity:
length generally 5 mm, deviation selectable.
