Operating Manual
- Page 40 -
7.1
F1 Menu (Enter or F1 Key)
Below is a list of functions which are found under the
ENTER
or
F1
key. These functions are
‘point-type’ functions, meaning that the values applied will occupy one memory address.
Please see
SECTION 8: Sample Programs
for additional programming examples.
7.1.1
Dispense Dot
Registers the current XYZ location as a dispense point for dot dispensing.
The dispense time and wait time must be set in a previous memory address by registering a
Point
Dispense Setup
instruction.
The upward motion of the tip after dispensing can be controlled by registering a
Dispense End
Setup
instruction and / or a
Z Clearance
instruction in a previous memory address.
Dispense End Setup
and
Z Clearance
instructions are registered using the
F4
key.
See also
7.4.3 Point Dispense Setup
,
7.4.4 Dispense End Setup
and
7.4.5 Z Clearance
.
7.1.2
Line Start
Registers the current XYZ location as a Line Start point for line dispensing.
The line speed must be set in a previous memory address by registering a
Line
Speed
instruction
using the
F4
key.
Dispense delay times used at Line Start and Line End points can be controlled by registering a
Line
Dispense Setup
instruction in a previous memory address. The
Line Dispense Setup
instruction is
registered by pressing the
F4
key.
See also
7.4.1 Line Speed
and
7.4.2 Line Dispense Setup
.
Summary of Contents for EQ RB20 500D
