Loctite EQ RB20 500D, Operation Manual, Page: 33 / 126

Operating Manual
- Page 33 -
Instruction Display Shows
8
The display will show we are at memory address 3 and it is
empty. Jog the tip to the X, Y, Z location of the second point
(
2: Arc Point ).
When the location is correct, press the
+
to register the location as a Line Passing point.
ADDR:4 PROG:5
EMPTY
9
Now jog the tip to the location of the third point
(
3: Line Passing ). When the location is correct, press the
+
to register the location as an Arc point.
ADDR:5 PROG:5
EMPTY
10
Jog the tip to the location of the fourth point
(
4: Line Passing ). When the location is correct, press the
+
to register the location as a Line Passing point.
ADDR:6 PROG:5
EMPTY
11
Repeat the step 8 – 10 to register the points 5 to 12
12
Jog the tip to the location of the thirteenth point
(
13: Line End ). When the location is correct, press the
+
to register the location as a Line End point.
ADDR:15 PROG:5
EMPTY
13
The line is now complete. The next step is to register the
dispense settings for the dots.
Press the +
to register the dot dispensing time.
Point Dispense Setup
-----Time:
Tail Time:
unit: sec
14
Type 1.5 to register a dispensing time of 1.5 seconds, then
press ENTER .
Type 0.2 to register a waiting time after dispensing of 0.2
seconds, then press ENTER .
ADDR:16 PROG:5
EMPTY
15
Jog the tip to the location of first dispense dot
(
14: Dispense Dot ). When the location is correct, press the
+
to register the location as a Dispense Dot.
ADDR:17 PROG:5
EMPTY
16
Jog the tip to the location of second dispense dot
(
15: Dispense Dot ). When the location is correct, press the
+
to register the location as a Dispense Dot.
ADDR:18 PROG:5
EMPTY