Load Cell Systems WDESK-L, Installation And User Manual

Page: 62 / 68

- 57 -
PROGRAM SELECTION: confirm  and use the arrow keys to select the desired program:

: basic program, setpoint management only.
 : weight remote display program with setpoint.

: monoproduct loading program.
 : monoproduct unloading program.

: 3 products batching.
 : 6 products batching.

: 14 product batching.
 : no program.

Set the weight reading mode (except for

program):
-

: the weight is received either by load cells or intelligent junction boxes or transmitters
connected to the instrument.
-

: the weight is received via serial port (WEIMOD or WEIRIP mode).

Set the approval status (only if

have not been set)
-

: not approved program;
-

: approved program, single interval*;
-

: approved program, multi-interval*;
-

: approved program, multiple range*;
* Contact technical assistance to request the proper manual and the correct procedures for
approval, indicating mandatory hardware code and serial number (see section INSTRUMENT
COMMISSIONING).

Set the active regulation on the instrument (only if

have not been set):
-
 : approved program according to EN45501:2015 and OIML R76:2006 for UE;
-

: approved program according to NIST Handbook 44; NCWM PUB 14 for North
America (NTEP).
When a W series instrument is used in combination with an intelligent junction box or a
weight transmitter, the approval status set on both devices must be the same.

Configure the connection to the CLM serie intelligent junction box or to the weight transmitter
(only if
 or  have not been set):
-

: intelligent junction box or transmitter connected to the instrument
-

: no intelligent junction box or transmitter connected