LNS GT 326-E, Instruction Manual, Page: 98 / 218

Chapter 8 OPERATION
8 - 21
GT 326-E
SERVICE PARAMETERS
(Password protected, only for trained technician)
SERVICE MENU
Main screen
BARFEED SETUP
Defines the Bar feeder length and position is Left/ Right
of machine.
BARFEED SETUP
1ST FEED LOADING FLAG POSITION

The bar stock first movement right after it
’s loaded
into the bar feeder. First Feed by Loading Flag.

This movement is called FIRST FEED . It is used to
locate the bar rear tip at the insertion position.

The FIRST FEED must be correctly set so that the
gap between the bar rear tip and collet of the
pusher is within 5mm.
PUSHER TYPE
Allow to choose pusher with collet or pusher with cone.
LOADING CYCLE ENABLE WHILE CLAMPING
DEVICE
Defines at End of Bar the loading cycle will initiate when
receiving the chuck signal open or close.
BARFEED