LNS GT 326-E, Instruction Manual, Page: 110 / 218

Chapter 8 OPERATION
8 - 33
GT 326-E
50 Retraction safety logic setup
Retraction safety switches are to confirm the bar feeder
is either retracted of in a safe position.
1. Retraction safety switch lit, the retraction system is
not safely positioned.
2. Retraction safety switch lit, the retraction system is
safely positioned.
74 & 75 Time for clamping (sec.)
Defines the time it takes for the chuck of the lathe to be
physically closed or open.
74 Device to close
Time for the chuck to close.
75 Device to open
Time for chuck to open.
NORMAL OPERATION
SIMULATION MODE
Attention! This mode is used for simulation purpose only.
It allows to test run the bar feeder without taking the
lathe interface into consideration. No bar stock should
be present on the magazine or in the bar feeder
TEST INTERFACE MODE
This mode is selected for test purpose only. It allows
testing the interface signals (Input/Output) of the PLC
RUN OFF
LNS factory test only.
It’s only used for special test.
F3: Mode