LNS GT 326-E, Instruction Manual, Page: 102 / 218

Chapter 8 OPERATION
8 - 25
GT 326-E
02- Pusher motion setup
Defines whether the pusher motion is allowed with the
chuck of the lathe closed during bar feeder in manual
mode.
1 When the lathe chuck is closed, no manual motion
of the pusher is allowed.
2 When the lathe chuck is closed, manual motion of
the pusher is allowed.
03- Loading interrupt if A2 or A4 not activated
Defines during a bar change cycle, the condition for
pushing the bar when the chuck of the lathe opens.
1 Neither A2 nor A4 signal is checked. During a bar
change cycle, when the chuck of the lathe opens,
the pusher will advance the bar to Top Cut position.
2 Either A2 or A4 signal is checked. During a bar
change cycle, either one of the signals is required
for pushing bar stock to Top Cut position when the
chuck of the lathe opens.
04- (A3) Priority load command from lathe (Refer to 05 for related setup)
Defines if A3 signal initiates the bar change cycle.
1 The bar change cycle initiates when the chuck of
the lathe opens at end of bar.
2 The bar change cycle initiates depending on
parameter 05 setup (End of Bar).
＊
Refer to the timing chart <1> on 8.6.2.1
05- EOB signal required by the lathe (Refer to 04 for related setup)
Defines when the new bar change cycle is initiated by
A3 signal.
1 Bar change cycle initiates when receiving A3 signal
after the End of Bar signal arises.
2 Bar change cycle initiates at any time when A3
signal is received.
＊
Refer to the timing chart <1> on 8.6.2.1