LNS GT 326-E, Instruction Manual, Page: 107 / 218

8 - 30
Chapter 8 OPERATION
GT 326-E
24 Automatic signal connected to (A2) (Refer to INTERFACE09 for related setup)
Defines if A2 signal (lathe in auto mode) is connected.
1 If INTERFACE09=1, Chuck signal A1 and Auto
signal A2 enables the feeding process.
If INTERFACE09=2, Chuck signal A1, Auto signal
A2 and Push signal A4 enables feeding process.
2 If INTERFACE09=1, Chuck signal A1 only enables
feeding process.
If INTERFACE09=2, Chuck signal A1 and Push
signal A4 enables feeding process.
＊
Refer to the timing chart <2> on 8.6.2.1
31 EOB calculated according to part length
(Refer to INTERFACE17, 18, 19, 20, 32, 33 for related setup)
Defines how the End of Bar position is calculated.
1 The End of Bar position is calculated by
“DIAMETER
& LENGTH: PART LENGTH
’’ setup.
2 The End of Bar position is calculated by
“END OF
BAR” setup and pusher position.
＊
Refer to the timing chart <4> on 8.6.2.1
32 R3 turns ON (Refer to INTERFACE17, 18, 19, 20, 31, 33 for related setup)
Defines when the End of Bar signal R3 turns ON.
1 R3 signal turns ON when the pusher reaches the End
of Bar position during chuck opened.
2 R3 signal turns ON when the last part is machined
with chuck closed after the End of Bar.
＊
Refer to the timing chart <4> on 8.6.2.1