LNS GT 326-E, Instruction Manual, Page: 103 / 218

8 - 26
Chapter 8 OPERATION
GT 326-E
06- Loading cycle enable
Defines when the new bar change cycle is enabled.
(This applied only if INTERFACE04=1)
1 At End of Bar the loading cycle will initiate when
receiving the chuck signal open.
2 At End of Bar the loading cycle will initiate after
receiving the chuck close signal (pusher with cone)
07- Lathe type setup
1 Fixed headstock lathe
2 Sliding headstock lathe
3 Camshaft lathe
09- Push signal from the lathe (Refer to INTERFACE24 for related setup)
1 Chuck signal A1 and AUTO signal A2 enables the
pusher to advance the bar stock.
2 Chuck signal A1 and M-Code Push A4 enables the
pusher to advance the bar stock.
＊
Refer to the timing chart <2> on 8.6.2.1
10- AUTO signal (A2) setup
When the lathe is switched to automatic mode, AUTO
signal A2 turns ON. This parameter defines the type of
A2 signal.
1 A2 signal is a latched signal.
2 A2 signal is a pulsed signal.