LNS Express 220 S2, Instruction Manual

Page: 29 / 119

26 CHAPTER 4: ELECTRICS
EXPRESS 220 S2/320 S2
1.3. Hydraulic pump motor
During the installation, ensure that the motor is wired in accordance with the supply voltage available.
The supply voltage of the bar feed system is indicated on the identification plate.
If the voltage does not correspond, the wiring of the motor must be modified:
Procedure:
·
Turn the bar feeder off (trigger QS1 and QM1)
·
Open the main safety cover
·
Unscrew the motor cover unit
·
Make sure that all motor terminals are off
·
Modify the terminal block wiring of the motor according to the diagram above
·
Close the cover unit of the motor and the main safety cover
·
Turn the bar feeder on (engage QS1 and QM1)