LNS Express 220 S2, Instruction Manual

Page: 9 / 119

6 CHAPTER 1: BASIC PRINCIPLES
EXPRESS 220 S2/320 S2
3. SAFETY INSTRUCTIONS
Only sufficiently qualified personnel with an understanding of the product may install, maintain
and repair the product, if necessary, and start rotation of the spindle. The customer must provide
the necessary resources for internal monitoring, maintenance instructions, organisation of the
work, training of personnel and availability of the instructions for installation and use. All persons
working with this device must have read and understood the instructions in this manual. LNS
accepts no responsibility for possible accidents or property damage caused when safety
instructions are not followed.
·
Do not handle the equipment without having
knowledge of the safety instructions and the
instructions for use. Safety instructions for
the bar feeder, as well as the CNC lathe,
must be strictly observed.
·
Non-qualified personnel, children, and
persons under the influence of alcohol or
medication
should not handle the
equipment.
·
Loose garments, long hair and jewellery can
be dangerous.
·
Do not remove any covers while the bar
feeder or the machine is under electrical
power.
·
Do not conduct any maintenance operations
during the automatic cycle.
·
Do not grasp moving or rotating objects, or
nearby elements.
·
If certain safety shields or safety covers are
removed to conduct maintenance, they must
be reinstalled as soon as the maintenance
work is completed.
·
No servicing should be carried out on the
interface or inside the electrical cabinet
while the bar feeder or the lathe is under
electrical power.
·
It is strictly prohibited to jump wire or remove
circuit breakers, master switches, and
especially safety switches.
·
To avoid any harm to persons or damage to
components, use only the indicated points
for lifting and moving the bar feeder. No one
should be near the hanging load, or within
the operating range of the overhead
hoist/crane, forklift, or any other means used
for lifting and transportation.
·
Do not knock the bar feeder while moving it
as this could damage it.
·
Do not move the bar feeder while it is
electrically powered on.
·
The work area surrounding the bar feeder
should always be clear of objects and well
lit. The presence of oil on the ground could
cause falls; it is important to keep the floor
clean on a regular basis.
·
Do not place the machine in a damp area
and make sure that water or oil does not
come into contact with the electrical
equipment.
·
Do not open the clamping unit (collet or
chuck) of the lathe manually when the bar
feeder is in automatic mode (Interface).
·
Each time the diameter is changed, also
adapt the spindle reduction tube.
·
The use of spindle reduction tubes is highly
recommended for machining bars with
diameters smaller than the maximum
capacity of the spindle.
·
Do not attempt to recharge the batteries of
the PLC.
·
For the use and maintenance of the bar
feeder, use only parts provided by or
recommended by LNS.
·
If it is necessary to move the bar feeder
once it has been originally installed, do not
reinstall it before first contacting LNS or its
local representative.
·
The bar should never extend more than 3
times its diameter beyond the lathe's
clamping unit without support.
·
LNS accepts no responsibility for possible
accidents or property damage caused when
safety instructions are not followed.