llaza WINBOX-350, Technical Manual

Page: 14 / 20

Page 14 - Copyright Llaza, S.A. - May 2012
WINBOX-350
Assembly instructions
3. INSTALLING THE ARMS
L
O
M
Remove the arm bracket pins and place them on
the corresponding side.
Now re-insert the pins, inserting the M6x12 tight-
ening stud
(L) , but do not tighten it all the way.
Use the groove in the lower part of the pin to turn
it, until the other M6x25 stud
(M) can be inserted
to the point at which it gives slight resistance.
4. INSTALLING THE ARM END PIECES
Insert the end pieces into the end of the arm, attaching them
using the DIN 7991, M10x60 bolt
(N) . Also position the plate
(O) for attachment to the drop bar profile.
The position of each end piece must correspond with the letter
marked on it.
(L = left, R = right)
N
By tightening or loosening this stud (M) and opening
and closing the arm manually, the level of the arm
joints can be adjusted so that they are exactly equal,
preferable slightly inclined towards the top. Once the-
se positions are adjusted, firmly tighten the upper stud
(L) .
PIN