20/45
3.4.
Install saw blade
Danger!
Removing or opening of the saw blade protective hood or reaching into the rotating saw blade
during cutting is prohibited. These works may only be carried out with the saw blade at a
standstill and the drive motor turned off.
Note
No rotating tools which have a maximum rotation speed smaller than the nominal speed of the
machine can be used.
Defective or broken tools must be replaced immediately.
In order to change the saw blade, the following steps must be carried out:
Rotate the saw arm to the uppermost position above the crank (Pos. 1)
Remove the hexagon head screw (Pos. 2)
Remove the flange nuts using the tool kit (SW36) and remove the pressure disc
Note
When installing the saw blade, ensure that the flange surfaces are clean. The saw blade must sit
directly on the flange. Match the direction of rotation of the saw blade with the rotation direction
arrow (synchronised sawing) on the saw blade protective hood.
Insert saw blade
Install the pressure disc and flange nut
Insert the locking pin
Remove the flange nuts using the tool kit (SW36) and remove the pressure disc
Plug-in the saw blade protective hood
1
2
3
4
