11/45
1.4.
Safety instructions for operation phases
1.4.1.
Transport, assembly and installation
1.4.1.1
Transport, assembly and installation on/with the floor saw may only be carried out in transport
position. Secure the floor saw against rolling away.
1.4.1.2
Transport, assembly and installation on/with the floor saw may only be carried out with removed
saw blade and when the drive motor is turned off.
1.4.1.3
The transport the floor saw in compliance with the maximum operating weight, this should be
exclusively done by crane.
1.4.1.4
The transport may only be done, as long as all machine parts are tightened on the machine and
individual parts cannot fall.
1.4.2.
Commissioning
1.4.2.1
The commissioning of the floor saw may only be carried out in transport position.
1.4.2.2
When inserting the saw blade, observe the running direction. The cutting process must always be
done clockwise, otherwise material is ripped out which causes small pieces of debris to fly around.
1.4.2.3
When inserting the saw blade, protect against sharp edges.
1.4.2.4
Ensure that the floor on which cuts are to be made fulfils load carrying capacities.. All obstacles
must be cleared away from the cutting area and make sure there is sufficient lighting.
1.4.2.5 Visual
inspection of the whole floor saw for damages and defects. Special check of the safety
equipment.
1.4.2.6
The steering rod must be set for the operator.
1.4.2.7
Keep water sources handy for cooling the saw blade.
1.4.2.8
No rotating tools which have a maximum rotation speed smaller than the nominal speed of the
machine can be used.
Defective or broken tools must be replaced immediately.
