7
Before you begin
Tools needed to assemble this shower cabin:
Electric screwdriver with a selection of heads, regular screwdrivers, pipe grips, spanners, spirit level, sharp
knife and rubber mallet. Connection of the electrical supply and plumbing may require additional tools.
There is a drill bit supplied with the kit, to allow either widening of holes or drilling new holes which you
feel cannot be located during construction.
Water requirements
This shower requires two water supplies (1 x hot and 1 x cold) tested to be between 1 and 3 bar, with
a fl ow rate over 7.5 litres per minute.
NOTE: We recommend water pressures over 2 bar to achieve optimum showering results.
Gravity Fed systems
If yo
tting a shower Pump is recommended. Fitting a Twin Impeller
Shower pump rated over 2 bar is necessary as a minimum. Shower pumps MUST be properly sited,
installed and commissioned. Incorrectly installed shower pumps will cause adver
acts to your
showering and bathing resulting in pulsing or starting and stopping of the pump. If a pump is installed,
a separate Mains Cold supply
tted and directed to supply the Steam Generator separately
(bypassing the pump).
Isolating Valves
Whilst not a requirement
en
the water supply to the shower when not in use (for example going away on
holiday). Additionally isolating valves makes service checks easier than locating the house stop cock.
Electrical
This model requires an electrical supply, this MUST be in the form of an ISOLATED FUSED SPUR. It is
t this shower to a plug socket in a Bathroom environment. The product
tted for testing purposes only and should be removed to
complete the install.
tting these as it
