9
1. FITTING THE SHOWER VALVE
The Thermostatic Shower Valve will need
to be fi tted into the central tower panel
into the three pre-drilled, vertical holes
available for it.
First remove the 3 Chrome Dials from the
valve.
The Selector Dial and ON/Off Dial are
removed by unscrewing the Chrome Lug
on the side. Once removed this should also
come free with the threaded grub screw part
in place, so the dial will now pull off .
The Temperature Dial has a small silver cap
on the opposite side to the Lug. Remove
this cap and insert a 2.5mm Allen Key inside
to the grub screw. Turn a small amount to
loosen (not remove) and then pull the dial
away.
Next unscrew each of the Chrome Dial
plates.
Now position the valve from the rear of the
central panel to align with the holes and
push through the holes.
Re-fi t each of the Chrome Dial Plates from the
front of the panel. This will now hold the valve in
position.
Adjustment can be made to the rear nuts to allow
the valve to be seated correctly against the panel.
Now you can re-fi t each of the chrome dials,
remembering to fi t the lower (thermostatic control
dial) on the lower most position.
Now the valve is in position and tight you can
fi t the two WRAS approved, Braided hoses to
the water inlets at the bottom of the valve in
preparation for connecting to water at a later
stage.
Connect also the silver/grey hose from the
overhead shower that is pre-fi tted to the upper
part of the central panel. Ensure this connection is
watertight.