37
WATER TIGHTNESS TEST
To ensure that you will have no leaks from your shower it is essential to perform a water tightness test.
With all connections fully tightened, hoses checked, jets fully sealed, your shower still roughly 18 inches from its
designated space and the silicone sealer fully cured for at least 24 hours. Switch on the overhead shower using both
the cold & hot water settings Now on the outside inspect each joint, hose, clip, jet, from one side going round to the
Dry area thoroughly and reseal on the outside, leave a further 24 hours to cure & then repeat the water tightness test.
Again remember where you see water may not be exactly where the leak is as it could have run round to a low point.
SERVICING YOUR PRODUCT
Like any system with complex parts, your steam shower will need a regular maintenance program to ensure a long
service life. We are always happy to discuss this and have an appropriate range of tools & compounds to help you.
Here are our recommendations.
Every 6 months
Isolate all electrical & water connections to your unit.
Pull your shower away from the wall.
Check supply water pipes for corrosion from lime scale, calcium build up
Check tightness of all joints tighten where required.
Check electrical connections for any obvious signs of poor original connection or other. If a repair is needed then
Check for signs of water leaks under the product or where it has been standing.
Remove overhead shower head and clean out any
calcium build up from the water holes.
Repeat with hand shower.
Check hand shower hose for wear.
Check door runner wheels for wear. Vaseline (or any light clean grease) lightly inside the runners to keep a smooth
action on your doors.
Disclaimer
: the data, examples and diagrams in this manual are included solely for the concept or product
description and are not to be deemed as a statement of guaranteed properties.
All persons responsible for applying the equipment addressed in this manual must satisfy themselves that
each intended application is suitable and acceptable, including that any applicable safety or other operational
requirements are complied with. In particular, any risks in applications where a system failure and/ or
product failure would create a risk for harm to property or persons (including but not limited to personal
injuries or death) shall be the sole responsibility of the person or entity installing the product, and those so
responsible are hereby requested to ensure that all measures are taken to exclude or mitigate such risks. This
document has been carefully checked by Lisna Waters but deviations cannot be completely ruled out. In case any
errors are detected, the reader is kindly requested to notify Lisna Waters Other than under explicit contractual com-
mitments, in no event shall Lisna Waters be responsible or liable for any loss or damage resulting from the use of this
manual or the application of the equipment. Please inspect all parts carefully before assembly. BY COMMENCING THE
ASSEMBLY OF THIS SHOWER YOU ACCEPT THAT THE PARTS HAVE ALL BEEN CHECKED AND ARE UNDAMAGED.