Lipco Reversing Harrow UF 100L, Translation Of The Original Instructions

Page: 17 / 24

Operating instructions Reversing harrow UF 70L/ 80L/ 90L/ 100L
17 - 24 LIPCO 110037B-20-E BA UF70L_80L_90L_100L / 29.12.2009

Check whether the cutting blade screws have been tightened.
Damaged screws have to be replaced immediately (see chapter
"11. Replacement of the cutting blades"). Note: Always use the
original steel nuts with fine pitch thread.

The drive flange must be lubricated once a month via the
lubricating nipple provided especially for this purpose and then
turned once to allow the grease to become distributed!

Make sure it runs smoothly. (Fig.4)

Remove drive flange once a year, clean and regrease it.

Lubricate the overload coupling (star ratchet) and universal joint
shaft of the drive every 8 operating hours and after a longer
standstill! (Fig. 9)

Lubricating points:

Lubricating nipple (3x)
Star ratchet
Joint
Joint
Fig. 9

Check the level of lubricant in the chain drive via the
corresponding plug (Fig. 11). This operation must be carried out,
when the machine has already been running for a few minutes,
and the grease has warmed up and become distributed evenly.
Then check the grease level with a dipstick (grease level should
be at least 5 cm, measured from the lowest point of the chain
case to ensure that the chain is always sufficiently lubricated).