Lipco Reversing Harrow UF 100L, Translation Of The Original Instructions

Page: 14 / 24

Operating instructions Reversing harrow UF 70L/ 80L/ 90L/ 100L
14 - 24 LIPCO 110037B-20-E BA UF70L_80L_90L_100L / 29.12.2009
8. Connection to the engine driven machine
Before attaching the machine flange (Fig. 4, Ref. A) corresponding to
the type of engine-driven machine you have, it is recommended
spreading grease on the outer diameter of the machine hub (Fig. 4,
Ref. B). Then insert the flange with its two threaded pins (Fig. 4, Ref.
C) and the two lock nuts. To attach the flange to the hub, proceed as
follows:

Screw the threaded pins in as far as possible and then unscrew
them by one turn. Tighten the lock nuts. After this operation,
make sure that the flange oscillates freely without squeezing or
blocking.

After having greased the connecting shaft (Fig. 4, Ref. D), insert
it on the machine shaft of the Reversing Harrow. When these
steps are complete, move the engine-driven machine close to
the unit. Ensure the toothed wheel work of the connecting shaft
engages correctly with the power takeoff shaft of the engine-
driven machine and the flange has a centred contact with the
engine-driven machine. Then secure the connection between the
engine-driven machine and the unit.
Before commencing work, lubricate drive flange on the lubricating
nipple (Fig. 4, Ref. E)!
Fig. 4
B