-37-
e.g. When the size is “16 bit” and the position is “2”.
The data in the net sweeps. In addition to the one to sweep it transmits the
data set in “Data”.
Sweep value
■
Set the target value on the right. Set
the in decimal “initial value”, “first
target value”, “second target value”,
and “third target value” from top to
bottom.
Press [±] to change the symbol of
the target value. Negative values are
transmitted by 2's complement.
Set the time for sweep.
Set the times needed to change to the “first target value”, “second target
value”, and “third target value” in millisecond from top to bottom.
With the setting in the display, it argument from 0 (initial value) to 100 in 1
second and then diminish it to –200 in two second. Then it changes the data
to 100 in 0.5 second.
When “Loop” is checked it keeps sweeping.
6.4 Start and stop of simulation
Setting and connection check
Check the measurement port selection, “Simulation” setting, and
communication condition.
→ 3.2 Functions
→ 3.3 CAN Configuration
→ 3.4 LIN Configuration
→ Chapter 4 Connect to the Target Devices
