Linak TECHLINE LA33, User Manual

Page: 34 / 76

Page 34 of 76
Actuator with proportional control
I/O specifications:
Input/Output Specification Comments
Green Endstop signal out Output voltage min. V
IN
- 2V
Source current max. 100mA
Endstop signals are NOT potential free.
Endstop signals can be configured with
BusLink software according to any position
needed
When configuring virtual endstop, it is not
necessary to choose the position feedback.
EOS and virtual endstop will work even
when feedback is not chosen
Yellow Endstop signal in
Violet Analogue feedback (0-10V):
Configure any high/low combination
between 0-10V Ripple max. 200mV
Transaction delay 20ms
Linear feedback 0.5%
Max. current output. 1mA
Single Hall output (PNP):
Movement per Single Hall pulse:
33090: Actuator = 0.3 mm per count
33150: Actuator = 0.5 mm per count
33200: Actuator = 1.1 mm per count
Frequency: Frequency is up to 125 Hz on
Single Hall output depending on load and
spindle. Overvoltage on the motor can
result in shorter pulses Output voltage min. V
IN
- 2V
Max. current output: 12mA
Max. 680nF
Digital output feedback PWM:
Configure any high/low combination
between 0-100% Output voltage min. V
IN
- 2V
Frequency: 75Hz ± 10Hz as standard, but
this can be customised.
Duty cycle: Any low/high combination
between 0 and 100 percent.
Open collector source current max. 12mA
Analogue feedback (4-20mA):
Configure any high/low combination
between 4-20mA Tolerances ± 0.2mA
Transaction delay 20ms
Linear feedback 0.5%
Output: Source
Serial resistance: 12V max. 300 ohm
24V max. 900 ohm
All absolute value feedbacks (0-10V,
PWM and 4-20mA) Standby power consumption:
12V, 85mA
24V, 50mA
It is recommendable to have the actuator
to activate its limit switches on a regular
basis, to ensure more precise positioning
White Signal GND For correct wiring of power GND and
Signal GND see page 37