Page 43 of 76
Actuator with Parallel
I/O specifications:
Input/Output
Specification
Comments
Green
Endstop signal out
Output voltage min. V
IN
- 2V
Source current max. 100mA
Endstop signals are NOT potential free.
Endstop signals can be configured with
BusLink software according to any
position needed
Yellow
Endstop signal in
Violet
Parallel communication:
Violet cords must be connected together
Standby power consumption:
12V, 85mA
24V, 50mA
No feedback available during parallel
drive
White
Signal GND:
White cords must be connected together
For correct wiring of power GND and
Signal GND see page 37
•
Current cut-offs should not be used as stop function! This might damage the actuator. Current
cut-offs should only be used in emergencies!
•
Current cut-off limits are not proportional with the load curves of the actuator. This means that the
current cut-offs cannot be used as load indicator.
•
There are tolerances on the spindle, nut, gear wheels etc. and these tolerances will have an
influence on the current consumption for the specific actuator.
Summary of Contents for TECHLINE LA33
Page 1: ...Page 1 of 76 LINAK COM TECHLINE Actuator LA33 User manual...
Page 74: ...Page 74 of 76...
Page 75: ...Page 75 of 76...
