MX8x8DVI-DL
User’s Manual Rev. 1.0
Page 49 / 75
7.3. Switching and control commands
7.3.1. Switch one input to one output
Description
: Switch input <in> to output <out>.
Format
Example
Command {<in>@<out>}
→
{1@5}
Response
(O<out²>●I<in²>)CrLf
←
(O05 I01)CrLf
Explanation
: Input 1 is switched to output 5.
7.3.2. Switch one input to all outputs
Description
: Switch input <in> to all outputs.
Format
Example
Command {<in>@O}
→
{02@O}
Response
(I<in
²>●ALL)CrLf
←
(I01 ALL)CrLf
Explanation
: Input 2 is switched to all outputs.
7.3.3. View connection on the specified output
Info
Obsolete! Use {VC} instead
Description
: View connection on output <out>.
Format
Example
Command {?<out>}
→
{?05}
Response
(O<out
²>●I<in²>)CrLf
←
(
O05 I01
)CrLf
Explanation
: Viewing connection for output 5. The connected input is 1.
7.3.4. View connection on all outputs
Description:
Viewing
all outputs‟ connection results in different response length,
because it
depends on the router‟s type (length = 8 for MX8x8DVI / MX8x8DVI-DL,
length = 6 for MX6x6DVI / MX6x6DVI-DL). The response below supposes a router
having 8 outputs.
Format
Example 1
(MX8x8)
Command {VC}
→ {VC}
Response
(ALL●<O1>●<O2>●<O3>
●<O4>●<O5>●<O6>●<O7>
●<O8>●)CrLf
←
(
ALL 02 02 02 05 05 05 08 08 )CrLf
Legend 1:
All <Ox> indexes show the corresponding output
‟s connection state. If
value <O5> equals 04 it means that output 5 is connected to input 4. <O1>..<O8>
are two digit ASCII characters. (01, 02, 04, etc.)
Explanation 1
: Viewing connection for all outputs. Input 2 is connected to outputs
1, 2 and 3. Input 5 is connected to outputs 4, 5 and 6. Input 8 is connected to
output 7 and 8.
Info
Note that a space character is sent after the last output
Info
If an output is locked, muted, or both locked and muted, the response format
changes. If outputs are muted you get a letter 'M', if locked a letter 'L' and if muted
and locked at the same time 'U' before the 2 digit numbers.
